On 25 January 2005, a Boeing 727-51C aircraft, registered in
Sierra Leone as 9L-LEK, was being operated on a non-scheduled
positioning flight from Cairns to Brisbane, Queensland. The crew,
which comprised the pilot in command, copilot and flight engineer,
were supported by an aircraft maintenance engineer (a passenger)
for away from base maintenance. The copilot was the handling pilot
for the flight.
Approaching Brisbane, the aircraft was cleared for an instrument
landing system approach to runway 01 at Brisbane Airport. There was
a 15 kts gusting crosswind from the east. The crew reported that
they had visual contact with the runway at about 1,000 ft altitude
and flew a stabilised approach to a normal touchdown at about 1606
eastern standard time. The wing spoilers and thrust reversers
deployed normally.
The copilot said that as the speed reduced through 100 kts, the
aircraft was tending to veer right and that, approaching 80 kts, he
had maximum left rudder applied to maintain the aircraft tracking
on the runway centreline. Nosewheel steering is controlled by the
rudder pedals and by a steering wheel on the pilot in command's
side panel. When the copilot is flying the aircraft, it is normal
procedure as the aircraft slows during the landing roll for the
pilot in command to take control of the aircraft to manoeuvre it
using the nosewheel steering wheel. In accordance with normal
procedures, the pilot in command took control of the aircraft at
about 80 kts. As the copilot relinquished control, he informed the
pilot in command that he had maximum left rudder applied.
The pilot in command said that when he placed his hand on the
nose wheel steering wheel, it felt very loose as he turned the
wheel left to maintain the aircraft on the runway centreline.
However, there was no response to the steering wheel inputs and,
despite the use of differential main wheel braking, he was unable
to prevent the aircraft veering right and running off the runway at
a speed of between 60 and 70 kts. The aircraft came to rest about
40 m from the runway edge, and was undamaged.
An examination of the nosewheel steering system revealed that
one of the carbon steel nosewheel steering cables, linking the
steering wheel to the nose gear steering valve, had failed
approximately 2.35 m from the ball end. That location was within
the forward fuselage section above the nose wheel where the cables
were hidden from view and not readily accessible.
A subsequent specialist examination of the failed cable
indicated that approximately 70 percent of the cable strands at the
failure location exhibited characteristics of severe aqueous
corrosion1. The remaining strands
showed decreased diameter due to corrosion and had failed under
applied tensile loads.
The aircraft had a total time in service of 54,200 hours and
48,000 flight cycles2. The operator
advised that the most recent maintenance check on the aircraft was
an 'A' check completed in December 2004 and the last 'C' check on
the aircraft in December 2003. The operator also advised that, in
its maintenance system for the aircraft, the nose wheel steering
cable was an 'on condition' item and that, during a 'C' check,
there was a requirement to conduct a visual inspection of the
cable.
1 Aqueous corrosion is an
electrochemical process by which metals or alloys are oxidised in
the presence of solutions containing water. Corrosion rates are
significantly affected by environmental conditions such as
temperature, humidity, and oxygen availability.
2 A flight cycle is a completed
takeoff and landing sequence.